RPC-600/610
Industrial chassis
9
2.2 System Setup
The following procedures are provided to assist you in installing drives, plug-in
cards and the hold-down clamp in to the RPC-600/610.
2.2.1 Removing the cover
Removing the chassis cover
，
place it in the flat surface, so as to avoid causing
scratches on the spraying surface of chassis cover.
1: Please use screwdrivers to twist both of host cover's sides of the screw by the
direction of anti-clockwise.
2: Seize the both sides of host cover, pull backwardly.
3: Take out the host cover and place it in a safe place to avoid scratches.
2.2.2 Install HDD
After removing host cover
，
You can easily install disk drivers
。
You should follow
these steps before installing disk drivers
：
1: Twist off the screws on fixed Drive Disk Enclosure with screwdriver,
Place it
inside the container.
2: Take the Drive Disk Enclosure Out of chassis with gloves, put it in the smooth
platform, preferably where is foam pad avoid knocking and stumbling
FDD
Install
：
Place FD into a 3.5-inch driver's location (At the bottom of driver),
Fix
FD with
screws on the both sides of Drive Disk Enclosure.
