65E Turbo Motor Grader
Service Manual
Service 2.00_2013.03
5
-
2
Section 5
Front Axle
The frame pivots at the upper and lower articulation pins. Refer to Section 07, Hydraulics, for articulation cyl
-
inder replacement and overhaul procedures.
Wheel Lean
Wheel lean is provided to create an aggressive bite in soft terrain. Oil flow for wheel lean is controlled by a
section on the main control valve. Input is received by operating the control lever on the front console.
Front Axle
The front axle pivots to allow smooth operation over rough terrain. Steering linkages allow for adjustment of
toe
-
in and camber.
S
PECIFICATIONS
Steering
Control Unit Make and Model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Eaton
Type. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Orbitrol
Turns Lock to Lock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 to Left; 6 to Right
Displacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120 cu. cm./rev. (7.33 cu. in./rev.)
Maximum Turn Angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40deg. from Center
Pressure Relief . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .107
-
120 bar (1550
-
1750 psi)
Cylinders
Steering (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 63.5 x 198.0 mm (2.50 x 7.80 in.)
Articulation (2) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76.0 x 276.0 mm (3.00 x 10.88 in.)
Wheel Lean (1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 76.2 x 138.4 mm (3.00 x 5.45 in.)
Torque Values
Front Wheel Lug Nuts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 440
-
475 Nm (325
-
350 Ib
-
ft.)
Wheel Lean Cylinder Linkage Rod Bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 542
-
678 Nm (400
-
500 Ib
-
ft.)
Front Wheel Bearing Bolts. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
-
27 Nm (10
-
20 Ib
-
ft.)
Steering Cylinder Jam Nut. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 122
-
150 Nm (90
-
110 Ib
-
ft.)
Steering Cylinder Socket Nut. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 108
-
135 Nm (80
-
100 Ib
-
ft.)
Steering Cylinder Lock Plate Bolts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 33
-
38 Nm (24
-
28 Ib
-
ft.)
Summary of Contents for 65E Turbo Motor Grader
