17
4.5.1
Boom Roll Sensor Mounting
The boom roll sensor (
E04
) must be
mounted to the rotating part of the boom.
Follow these guidelines and refer to and
Figure 16
and
Figure 17
to mount the
sensor.
a)
Make sure you are using the roll sensor
that does NOT have a temperature
probe (only one cable) (
E04
).
b)
The boom roll sensor must be mounted
to the rotating part of the boom
suspension.
c)
Use cable-ties to secure the bracket to
a square edge feature (square tube).
d)
Ensure the AMP (circular) connector
exits towards the Right Hand Wing
(when looking from the rear of the
sprayer).
e)
Securely cable-tie the connector to the
frame.
4.5.2
Chassis Roll Sensor Mounting
The chassis roll sensor must be mounted to
a non-rotating part of the boom. To mount
the chassis roll sensor, follow the following
guidelines and refer to
Figure 16
and
Figure 17
.
a)
Make sure you are mounting the roll
sensor that does have a temperature
probe (2 cables) (
E03
).
b)
Mount the chassis roll sensor (
E03
) to a
non-rotating part of the boom.
c)
Cable-tie the bracket to a square edge
feature (square tube).
d)
The AMP (circular) connector
MUST
exit towards the Right Hand Wing
(when looking from the rear).
e)
Securely cable-tie the connector to the
frame.
Summary of Contents for UC4 Plus Rogator 64 Series
