6505 Gayhart St., Commerce, CA 90040 | Phone: 800.686.6672 | FAX: 800.500.9955 www.noralighting.com | e-mail: [email protected]
Specifications subject to change without notice. © 2016
®
FOR LED/DEDICATED HOUSINGS:
1. Connect orange female to male connecter and ground wire of the fixture to housing (Fig.4).
Connector is not intended to support weight of the fixture. Please support fixture at all times.
2. Squeeze in mounting blade on both side and carefully push fixture into the housing (Fig.5)
3. Aim fixture straight down r angle towards a focal point.
Medium Based Housing:
1. Place provided LED Lamp Replacement Marking Sticker inside the
housing where visible to installer.
2. Remove medium-base mounting bracket only if necessary to provide
room for fixture to be installed fully and properly into the housing. (fig. 7)
3. Use provided Medium-base socket adapter and attach each end to
housing and fixture. (fig.8)
4. Aim fixture straight down r angle towards a focal point.
Only those open holes indicated in the photographs and/or drawings may
be made or altered as a result of kit installation.
Do not leave any other open holes in
an enclosure of wiring or
electrical components.
Remove bracket
if necessary.
FIGURE
4
FIGURE 7
FIGURE 8
FIGURE
5
Male Connector
Male Connector
Male Connector
Female Connector
Ground Wire
Ground Wire
Converting Medium Based Housing to Dedicated:
1. Place provided LED Lamp Replacement Marking Sticker
inside the housing where visible to installer.
2. Cut Medium-base socket adapter (Figure A)
3. Replace with provided male orange connector (Figure B)
4. Connect ground & fixture to housing (Figure C)
5. Squeeze in mounting blade on both side and carefully push
fixture into the housing (Fig.5)
6. Aim fixture straight down r angle towards a focal point.
FIGURE A
FIGURE B
FIGURE C
