background image

6505 Gayhart St., Commerce, CA 90040   |   Phone: 800.686.6672  |  FAX: 800.500.9955 www.noralighting.com   |   e-mail: [email protected]    
Specifications subject to change without notice.  © 2016

®

ALWAYS TURN OFF MAIN POWER BEFORE INSTALLATION

INSTALLATION SHOULD BE CARRIED

OUT BY YOUR LOCAL ELECTRICIAN.

Installation Instructions

NRMC2 Series 

Marquise II

 

Retrofit

***IMPORTANT: READ PRIOR TO ATTEMPTING INSTALLATION***

WARNING: Fire/Electrical Hazard

This equipment is intended to be installed only by qualified personnel. The installation must be made in accordance with the 
current edition to the National Electric Code and all applicable state and local building codes. The final installation must be 
approved by the appropriate qualified electrical/building inspector(s). Improper installation may result in a fire or electrical hazard. 
Be sure the electrical power to the circuit has been disconnected before installing this electrical system.

AVERTISSEMENT : Fire / Risque électrique

Cet équipement est destiné à être installé uniquement par du personnel qualifié . L’installation doit être faite en conformité avec 
l’édition actuelle du Code national de l’électricité et toutes étatiques et locales codes du bâtiment applicables . L’installation finale 
doit être approuvée par l’ inspecteur en électricité / bâtiment qualifié approprié ( s) . Une mauvaise installation peut entraîner 
un incendie ou un risque électrique . Soyez sûr de la puissance électrique vers le circuit a été coupée avant l’installation de ce 
système électrique .

Fig. 1  

Marquise II Trim

Fig. 3 

Fig. 2 

Retrofit Kit

 

a. 

Medium-base socket adapter

 

b. 

Male Ideal

®

 Connector

 

c.  

LED Lamp Replacement Marking Sticker 

A.

B.

C.

B. HOUSING DIMENSIONS

A. PACKAGING CONTENTS

4”

5”

6”

Min.Height

5-1/2”

5-1/2”

5-1/2”

Width

4-1/8”

5-3/8”

6-1/8”

C. ELECTRICAL RATINGS

Refer to correlation label of luminaire and/or specification 
sheet in Nora’s website. www.noralighting.com

Safety tests was conducted in minimum housing 
dimension specified above (Fig. 3). Luminaire 
malfunction and overheating may occur if installed 
into a smaller housing.

Reviews: