5
NookBox
Installation Guide
Water Detector
Mounting Water Detector
The Water Detector can be deployed on the ground or mounted on the wall.
Ground Deployment
When deployed on the ground, the Water Detector detects water through the probes protruding from its back cover.
1. (If extension probe is connected) Open the cover by removing the bottom fixing screw on the Water Detector.
2. Remove the extension probe from the terminal.
3. Replace the cover.
4. Put the Water Detector on the ground with the back cover facing downward.
Wall Mounting
For wall mounting, the Water Detector must be connected to the external extension probe, then installed at desired height.
1. Remove the fixing screw and cover assembly.
2. Use a Philip screw driver to turn counter-clockwise and loosen the 2 screws on the extension probe terminal. (Figure 1)
3. Insert the extension probe into the terminal, use the Philip screw driver to turn clockwise and tighten and screws to
secure the probe. (Figure 2)
4. Break through the wall mounting knockouts on the base.
5. Using the holes as a template, drill holes in the surface.
6. Insert the wall plugs if fixing it into plaster or brick.
7. Screw the base into the wall plugs.
8. Screw the cover back onto its base.
9. Find the plastic clip included in the package, insert the extension probe in the clip. (Figure 3)
10. Remove the cover double-side adhesive tape on the clip and apply the clip to desired location on the wall to secure the probe.
Figure 1
Figure 2
Figure 3
