NOOA NO601H, Instruction Manual

Page: 5 / 25

WARNING INDICATIONS
Low Battery warning
If the scale shows “Lo”, it indicates that the batteries are
too weak and it is time to replace the batteries. Refer to
the section "REPLACING BATTERIES" to replace
batteries.
Overload warning
If the scale shows “Err”, it indicates that the scale is
overloaded. The maximum capacity is indicated on the
scale. Step off the scale to avoid causing damage to the
scale.
Low Fat warning
If the scale shows “ErrL”, it indicates that your body fat
portion is too low. Please consult your doctor or
nutritionist for professional advice.
High Fat warning
If the scale shows “ErrH”, it indicates that your body fat
portion is too high. Please consult your doctor or
nutritionist for professional advice.
Error warning
If the scale shows “C”, it indicates that there are
measuring errors. Please step off the scale and retry.
(2) Measuring the body weight and analysis of proportion of body fat, body water
and body muscles.
1. Press the SET (ON/SET) button, the display will show the last measurement record of the last User
ID code.
2. Press the Up/ Down button to select the data profile (1–12). Gently tap on the scale platform with
your hand or foot. The display will show the last measurement record of your User ID code.
3. Wait until the display show zero. Step barefoot onto the platform and do not move. Ensure that you
are standing on the two electrodes. The scales will start to measure immediately. After flashing, the
weight display will show the result.
4. The body fat/ body water/ body muscle/ bone/ calorie analysis is beginning; remain standing on the
two electrodes. The measurement lasts a few seconds (display indication oooo) and the body fat
index LED bar at the middle of the scale will light on.
5. The display then shows the measured values three times to show current weight, increased /
decreased weight compared to last measurement, body fat index, the percentage of body fat , body
water, body muscle, bone and calorie requirement. The scales switch off automatically after these
values have been displayed.
NOTE: The display will show "C", if you do not stand on the two electrodes during weighing.
to switch on
Press SET(ON/SET)
Show parameters
of the last user or
default parameters
Press
to select user
code or reset
parameters
LCD shows "0.0"
Step onto weighing
platform gently
(both feet touching with
metal electrodes)
Wait until the digits stabilize
Weight readings locked
and flash once
Measuring...
Shut down automatically
Tap on the
scale platform
LCD shows last measuring
record of the 3rd user (No
record in the first time of use)
LED light up bars
Power off
Measured results (Repeat for 3 times and saved. The reading will re-appear at next
measuring for users' reference) Weight: 52.8kg, increase by 0.8kg, Fat status ,
Fat 23.8%, Hydration 52.3%, Muscle 37.2%, Bone 12%, Calorie 1840.
7 8
Always remove your shoes and socks, and clean your feet before use. Place even weight on each leg
and do not move. Make sure your feet are in good contact with the two electrodes on the scale
platform.