Revised: 06/01/12
North America: 800.732.9395 Europe: +353.98.66011
Insert extrusion into front slot with channel
facing outwards. Tighten with hex wrench
provided.
Repeat step 6 with top profile graphic.
Insert two jam nuts into the extrusion
channel from the top. Slide it into
position and twist until tight.
Your vertical profile graphic assembly is
complete.
Guide holes in bottom profile onto
screws. Attach with two caps and twist
until tight.
Connect top extrusion to bottom
extrusion and tighten with hex wrench
provided.
Vertical Profile Setup Instructions
Follow steps on the “Graphic & Light
Instructions”.
Lay out vertical profile parts.
Tap insert out of foot from underside.
Slide extrusion into front slot with
channel facing outward. Tighten inside
lock hole with hex wrench provided.
HangTen
Follow steps 1-10 on the HangTen
“Frame Setup Instructions”.
Note: When tightening with hex wrench always give it a 1/2 turn clockwise until tight.
Accessories • 11
