1. Grasp plug and remove from its power source.
To Replace a Fuse:
2. Locate blown fuse by sliding access cover on top of plug towards prongs.
USER SERVICING INSTRUCTIONS
3. Remove blown fuse by turning the plug over. Fuses should fall into your hand (gentle
tapping may be required).
5. Insert spare replacement fuse. Close fuse cover by sliding fuse access cover towards the cord.
4. Locate spare replacement fuse in plastic bag.
A) Power supply cord fuse replacement (replaceable 3 A, 125 V fuse is located in the plastic bag):
CAUTION
:
To reduce risk of fire, replace fuse in power supply cord with only 3 A, 125 V
fuse. Do not replace attachment plug.
Contains a safety device (fuse) that shall not be removed.
Caution
c) Before using or reusing, inspect product carefully. Discard any products that have cut, damaged,
or frayed wire insulation or cords, cracks in the lampholders or enclosures, loose connections,
d) When storing the product, carefully remove the product from wherever it is placed, including
or exposed copper wire.
Use and care instructions
a) When the product is placed on a live tree, the tree should be well maintained and fresh. Do not
place on live trees in which the needles are brown or break off easily. Keep the live-tree holder
b) If the product is placed on a tree, the tree should be well secured and stable.
filled with water.
trees, branches or bushes, to avoid any undue strain or stress on the product conductors,
e) When not in use, store neatly in a cool, dry location protected from sunlight.
connections, and wires.
Discard product if the attachment plug is damaged.
To Replace a Lamp:
1. Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
2. Unlock the burned out LED lamp by lifting the hook.
4. Replace lamp with only 3.0 Volt, 20 mA push-in type LED lamp (provided with product). Always
5. Lock the hook of lamp base by pushing lock down into the tab.
3. Pull lamp and plastic base straight out of lampholder.
match the hook to the tab.
Hook
Tab
Unlock
Lock
If the lamp base of the replacement lamp does not fit in the string: (as shown below by the Figs.)
b) Straighten the two wires on the end of the original burned-out lamp and remove the lamp base.
c) Straighten the wires on the end of the new lamp and remove
a) Pull the reflector out.
the lamp base.
on the cord tag near the connected product’s receptacle.
Connecting Sets End to End
(for connect multiple products)
When multiple products are connected together, do not exceed the lowest of the indicated maximum wattage
e) Insert the reflector into the base.
lamp to the hook on lamp base).
lamp base and bend the wires back (always match the long lead of new
d) Guide the two wires of the new lamp into the two holes of the original
T
S
-
C
22
3
A
. M
A
X
USE ONLY
125V FUSE
125V FUSE
OPEN
