2
3. Insert the middle section (B) of the tree into the bottom section (C).
Rotate the middle section (B) on right or left
direction until it falls into place, then insert vertically and tightly into the bottom section (C) to ensure
proper
circuit connection
. (Fig. 2)
4. Insert the top section (A) into the middle section (B).
Rotate the top section (A) on right or left direction until it falls
into place, then insert vertically and tightly into the middle section (B) to ensure
proper circuit connection
. (Fig.
3)
5. Allow the branches to fall into place or gently pull branches up and out. When adjusting branches be sure that all
wires are free of branch hinges. (Fig. 4)
6. Shape the branches. Starting with tips closest to the pole, shape one tip to the right, one to the left and one at the
centre of the main stem. Repeat pattern for each branch. (Fig. 5)
7. Plug cord from base to electric outlet. Please note this tree comes with an on/off foot pedal switch for easy
illumination.
TROUBLESHOOTING
If any lights do not work on your pre-lighted tree, please check the following:
1. If entire tree or a section of the tree does not light:
a) Make sure each section of the tree is well connected.
b) Check that there is power at the electrical outlet.
c) Check fuse in the extension cord and replace if necessary (see
Fuse Replacement
below).
2. If a strand of lights still does not work:
a) Check that all bulbs are tightly fitted inside the sockets and that no bulbs are broken or missing. Replace any
broken or missing bulbs with replacements bulbs provided (see
Bulb Replacement
below). If all bulbs are
firmly in the sockets, slightly twist the bulbs from side to side to ensure proper connection.
b)
If the lights still do not work, carefully remove each bulb one by one from the problem light string. Pull the
bulb AND plastic base straight out of the socket. Do not twist bulbs while removing from sockets. Check the
two wires at the bottom of the bulb holder. Each wire should be aligned properly on the bulb holder to ensure
a proper connection in the lamp socket. If one wire is missing or too short, please replace bulb with a
replacement bulb (provided).
CAUTION! – ALWAYS UNPLUG YOUR TREE FROM ITS
POWER SOURCE BEFORE ATTEMPTING BULB
REPLACEMENT.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed
,
including the following:
a)
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
b) Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When products are used in
outdoor applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not provided,
contact a qualified electrician for proper installation.
c) This seasonal use product is not intended for permanent installation or use.
d) Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.
e) Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
f) Do not let lamps rest on the supply cord or on any wire.
g) Unplug the product when leaving the house, when retiring for the night, or if left unattended.
h) This is an electrical product, not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not be
played with or placed where small children can reach it.
i) Do not use this product for other than its intended use.
j) Do not hang ornaments or other objects from cord, wire or light string.
k) Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
l) This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse
blows, unplug the product from the outlet. Also unplug any additional strings or products that may be attached to the
Helene Roulston 2013-3-11 10:45 PM
Deleted:
Helene Roulston 2013-3-11 10:45 PM
Deleted:
Helene Roulston 2013-3-11 10:46 PM
Deleted:
Helene Roulston 2013-3-11 10:46 PM
Deleted:
Helene Roulston 2013-3-11 10:48 PM
Deleted:
Helene Roulston 2013-3-11 10:49 PM
Deleted:
Helene Roulston 2013-3-11 10:51 PM
Deleted:
Helene Roulston 2013-3-11 10:51 PM
Deleted:
