6
8
9a
Assembly
4. Fan Assembly to Mounting Bracket
5. Blade Assembly to Motor
6. Installing the Light Fixture
· Using the fan blade screws, attach the fan blades between
· If there are plastic tabs shaped like bottle caps, remove
and discard them. These are stabilizers that protect the
motor during shipping.
· Remove blade bracket screws on the bottom of the
motor and use them to attach the blade assembly to the
motor. Ensure the screws are tightened (see Fig. 9b).
the fan blade brackets with the desired finished side faced
down on the fan blade brackets (see Fig. 9a).
· Remove the light kit screws from the light kit. Connect
the blue wire from the switch housing to the blue wire
from the light kit, and the white wire from the switch
housing to the white wire from the light kit simply by
joining the connector plugs together. Be sure the push
in type terminals snap into place (see Fig. 10a).
· Carefully put the wires into the switch housing .
· Attach the light kit by connecting the switch housing
cap to the fan switch housing, then tightly secure light
kit screws that were previously removed from the light
kit (see Fig. 10a).
· Install two 60 W (max.) candelabra bulbs or equivalent
CFLs (not included) into the sockets on the light kit
(see Fig. 10b).
.
.
Installing the Light Kit
Installing Bulb
ASSEMBLY
Note:
The dimmer function does not work if CFL bulb
is used. There is only ON/OFF function.
Toll-free: 1-866-827-4985 · model no. 052-6940-2
10a
10b
. Unhook the assembly from the mounting bracket.
. Hold the assembly by the canopy and raise up to
align the two holes in the canopy with the holes in
the mounting bracket.
. Tighten the loosened screws. Now re-secure the
screws and washers which were removed(see Fig. 8).
9b
7c
7d
7e
WARNING
:
Be sure no bare wire or wire strands are visible after making connections. Place
green and white connections on opposite side of box from the black and blue (if applicable)
connections.
7c
7d)
7e
