If the device receives a lot of noise when the search coil is held in the air, the cause may be
electromagnetic interference or a high sensitivity setting. If you suspect electromagnetic
interference, you may change the frequency. There are 5 frequencies in the device. The
factory default is 03. Normally, the frequency setting is not enabled and it is grayed out in the
menu. To activate it, while holding the pinpoint button pressed, press one of the
up/down/+/- buttons. Then, you can select the frequency option in the menu and change it.
IMPORTANT!
Frequency shifting may affect the performance of the device. Therefore, it is
recommended that you do not change the frequency unless necessary and keep it at the
factory default.
VOLUME:
This control allows you to increase or decrease the device's volume based on your
preference and environmental conditions. Volume level can be adjusted from 0 to 20.
When you turn off and on the device, it will start with the last volume level you chose. This
setting is common to all modes; changes will take effect in all modes. Because the volume
level affects power consumption, we recommend you not to increase it more than
necessary.
BRIGHTNESS:
This control allows you to adjust the backlight level of the numeric display on the handle
and the LCD panel on the system box based on your preference and environmental
conditions. Brightness level can be adjusted from 0 to 20. This setting is common to both
displays; changes will take effect on both. When you change the brightness level in the
menu, the backlight will turn on the numeric display and number ''88'' will appear for easy
adjustment. When you turn off and on the device, it will start with the last brightness level
you chose. This setting is common to all modes; changes will take effect in all modes.
The brightness level of the LCD panel on the system box affects power consumption a lot.
Therefore, the backlight illuminates during menu access and ground balancing. It does not
illuminate during searching or target detection. On the other hand, the brightness level of
the numeric display on the handle affects power consumption relatively less. It illuminates
during target detection and pinpointing. Especially if you are using the menu frequently,
we recommend that you choose the minimum brightness level that you can see in for
longer battery life.
cm/inch:
Adjusts the system of unit of the estimated depth provided during pinpointing. Once you
select this option in the menu, you can choose between cm or inch.
LANGUAGE:
Is used to change the language of the device. The
FORS Relic
menus can be viewed in 10
languages. At initial startup, the factory default language will be displayed. The user can
change the language in the menu. When you turn off and on the device, it will start with
the last language you selected.
Language is placed as the last option in the menu so it is easy to find in case the language
is changed to a foreign language by mistake. For languages written from right to left, the
screen layout is also designed that way.
DEVICE INTRODUCTION
Page 11
