1.1 SAFETY
It is therefore strictly forbidden to cover or block the air intakes or outlets at the
risk of causing an accident or damaging the heater.
All service operations must be performed by a qualified and authorised person
after the power has been switched off.
The installation must include an omni polar circuit breaker with a contact opening
gap of at least 3 mm.
The heater must not be installed underneath a power socket.
Comply with the minimum installation distances from floors, walls, furniture, etc.
The power supply must be protected by a residual current device of at least 30
mA, especially when installed in a room with a bath or shower.
When installing the heater in bathrooms, it must comply with local regulations.
If the power supply cable is damaged, it must be replaced by the manufacturer,
its after-sales service or a person with similar qualifications in order to prevent
any potential hazards.
Avoid installing the heater in a draught which may otherwise affect its thermostat
control.
This direct electric heater is designed for ambient heating of residential type
rooms, or similar, in new or existing, single and multi-unit dwellings.
Do not use this heater in the immediate surroundings of a bath, a shower or a
swimming pool.
(*) These instructions were correct at the time of the heater's manufacture and comply
with the standards applicable as at that date. The company reserves the right to modify
the Installation and User Guide at any time in order to take into account any new
standards or changes to existing standards.
The heater risks overheating
if it is covered. The following
logo reminds users of this risk.
4
CAUTION :
DO NOT COVER.
4.
Summary of Contents for 7358-3TWIFI
Page 13: ......
