www.nodis.it
Instruction Manual
Filling with water
1. Ensure the iron is disconnected from the power supply.
2. Turn the steam control knob to position “0” or Minimum
3. Fill with water through water filling inlet. (Do not exceed main level mark on the water tank.)
setting the temperature
• * Synthetics/Silk
• ** Wool
• *** Cotton/Linen
- Stand the iron upright
- Set temperature control (M) to ironing temperature.
- Inset the mains plug into the main supply.
- After the indicator light has gone out and come again, you may start ironing. The indicator light will go out
from time to time during ironing.
steam – ironing
• Set the temperature control (M) to position (*) or (**) for moderate steam and to (***) for maximum steam.
With conventional steam irons, water may leak from the soleplate if too low temperature has been selected.
- Ensured that there is enough water in the water reservoir.
- Stand the iron on its heel
- Insert the mains plug into the wall socket.
- Wait a little while for the indicator light to go out and come on again
- See the variable steam knob to adjust the steam.
Burst of steam
• By pressing button (F) and intense “Burst” of steam is emitted from the soleplate
• To prevent water leaking from the soleplate, do not keep the steam control button depressed for more than 5
seconds.
spray setting
• At any temperature by pressing the spray button (L) a couple of times the laundry can be damped down to
make them softer and easy to iron.
• Ensure that there is enough water in the water reservoir.
Dry ironing
• Turn the variable steam knob (L) to the position “0” or Minimum (=no steam)
self cleaning
It is important to apply “self-cleaning” at least every two months to remove impurities etc.
The harder the water the more the iron should be self-cleaned.
•
Open the filling funnel and fill the water reservoir up to the MAX position, then close the filling funnel.
•
Set the temperature control to MAX.
•
Insert the mains plug into the wall socket.
•
Allow the iron to heat up until the temperature pilot light goes out. Then set temperature dial to position MIN
•
Hold the iron horizontally over the sink, then remove the variable steam control knob from the body enabling
the iron to self clean
•
Boiling water and steam will now be ejected from the holes in soleplate. Impurities are washed away with it.
Move the iron forwards and backwards while this happened.
•
Set the steam control to “0” position when the water reservoir has become empty.
•
Repeat self-cleaning if you notice that much impurity or other has been washed out.
•
Move the iron over a (preferably) old piece of cloth.. this is to ensure that the soleplate will be dry during
shortage
•
Unplug and allow the iron to cool down before storing it.
Vertical steam
• The appliance is capable of generating steam even when in the vertical position, This function is especially
useful for refreshing clothes and curtains.
Anti-drip
• The appliance is fitted with an anti-drip device to enhance steaming and prevent drips of water from the
soleplate.
Anti-calc
• The appliance is fitted with an anti-calc device to reduce lime-scale build up in the steam chamber and extend
the product life.
Automatic shut off
The automatic shut off device trips after the iron has been left for approx. eight minutes in the upright position
or unused for approx. Thirty seconds in the horizontal position. The light comes on to indicate that shut off has
tripped. As soon as you move the iron, the device turns off and the iron starts working again.
4
5