Noblelift SPN22, Instruction Handbook Manual

Page: 15 / 16

14

Apply oil or grease to fittings as needed.

Consult detailed Lubrication List to lubricate the stacker.

Recharge the battery.

Disconnect and clean the battery. Apply dielectric grease to the battery electrodes.
NOTE: In addition to the above, instructions provided by the battery supplier should also be observed.
MEASURES TO BE TAKEN DURING STORAGE
Every two months: charge the battery.
IMPORTANT: It is important to recharge the battery regularly. Batteries allowed to completely discharge may become
damaged and require replacement.
RE-COMMISSIONING

Clean the stacker thoroughly.

Consult detailed Lubrication List to lubricate the stacker.

Clean the battery, apply dielectric grease to electrode bolts and connect the battery.

Recharge the battery.

Check for any moisture in the hydraulic oil, replace if required.

Check all safety functions before using.
BATTERY OPERATION
In the case of a fault in the electrical system, brush all exposed electrical connections or clean with contact cleaner.
Repeat this step to remove oxidation on controller connections.
TROUBLESHOOTING CHART
Fault Reason Treatment
Forks won't lift
1. Hydraulic oil is low
2. Blown fuse
3. Battery level is below 20-30% 1. Check hydraulic oil and add if needed
2. Check fuse; replace if necessary
3. Charge the battery
Forks won't
lower
1. Control valve is blocked with dirty
fluid
2. Lowering valve is off or damaged 1. Check hydraulic oil and clean control valve.
Replace hydraulic oil if necessary
2. Check lowering valve and replace if needed
Forks won’t stop
lifting Lifting micro switch is damaged Turn off power and replace lifting micro switch
Poor directional
control Pedal plate for brake interfere the chain
for steering Release the brake, let the pedal plate be level.
Hydraulic Flow Diagrams