16
Red LED flashes, indicating
energy reserve is less than 10%, need charging
immediately
Red
、
yellow
、
green LEDs light up at the same time, indicating accelerator is
breakdown
c. Charging
The attached automatic charger is only available for the optional voltage of 110V or
220V as referred.
The room, where you are charging must be ventilated.
Park the truck at a dedicated secured area with a dedicated power supply.
Disconnect the battery plug (11), take out the battery. Connect the external charger
plug to the power supply first, the charging status indicator lights up, then connect the
battery to the charger. After a few seconds, the charger goes into the charging mode
(charging status indicator: please refer to the instruction on the truck);
If the charger does not turn into charging mode, it means the battery voltage is too
low, the polarity is connected reversely or connection terminal is not well connected.
When charging is finished, disconnect the connector from the socket and place it in the
designated pocket.
8. REGULAR MAINTENANCE
Only qualified and trained personnel are allowed to do maintenance on this truck.
Before maintaining, remove the load from the forks and lower the forks to the lowest
position.
If you need to lift the truck, follow chapter 4d by using designated lashing or jacking
equipment. Before working, put safety devices (for instance designated lift jacks,
wedges or wooden blocks) under the truck to protect against accidental lowering,
movement or slipping.
Please pay attention by maintain the tiller arm.
Use approved and from your dealer released original spare parts.
Please consider, that oil leakage of hydraulic fluid can cause failures and accidents.
It is allowed to adjust the pressure valve only from trained service technicians.
If you need to change the wheels, please follow the instructions above. The castors
must be round and they should have no abnormal abrasion.
Check the items emphasized maintenance checklist.
