16
After starting the truck by activation from Pin-code panel carefully move the tiller to the operating zone
(‘F’, fig.11).
Turn the accelerator button to the desired direction forward ‘Fw.’ Or backwards ‘Bw.’(fig. 11).
Control the travelling speed by moving the accelerator button (28) carefully until you reached the desired
speed. If you move the accelerator button back to the neutral position, the controller decelerates the
truck until the truck stops. If the truck stopped, the parking brake will be engaged.
Drive carefully the truck to the destination. Watch the route conditions and adjust the travelling speed
with the accelerator- button.
Press turtle button (Fig.7, 32) to enter into slow speed mode, travel slowly by moving the accelerator
button (Fig.7, 28) , press turtle button again to return back to regular mode.
Press turtle button and hold for 2 seconds to activate driving function with tiller in its vertical position
when operating in confined areas. The driving function is active only when turtle button is pressed (the
speed is reduced); the release of turtle button will cause immediate stop. The activation of accelerator
button in time gap shorter than two seconds after the turtle button is pressed will not activate the driving
function, the activation cycle has to be repeated from the beginning. Accelerator button should remain in
neutral position till two seconds passed.
f. Steering
Y
ou steer the truck by moving the tiller to the left or right side. When travel in front direction (opposite to
direction of forks) the turning of tiller bar to right side will cause the truck turning clockwise.
g. Braking
PLEASE CHECK THE BRAKING DISTANCE WITH TRUCK BEFORE OPERATION
THE BRAKING PERFORMANCE DEPENDS ON THE TRACK CONDITIONS AND
THE LOAD CONDITIONS OF THE TRUCK
The braking function can be activated on several ways:
•
By moving the accelerator button (28
) back to the initial ‘0’ position or by releasing the button, the
regenerative braking is activated. The truck brakes until it stops.
•
By moving the accelerator button (28) from one driving direction directly to the opposite direction,
the truck brakes regenerative until it starts traveling into the opposite direction.
•
The truck
brakes, if the tiller is moved up or down to the braking zones (‘B’). If the tiller is released,
the tiller moves automatically up to the upper baking zone (‘B’).The truck brakes until it stops.
•
The safety (belly) button (18) prevents the operator from being crushed. If this button is activated,
the truck decelerates and/ or starts
traveling into the backwards direction (‘Bw.’) for a short distance
and stops. Please consider, that this button also operates, if the truckis not traveling and the tiller is
in the operating zone.
