No Wires Needed Parrot 1100, User Manual

Page: 11 / 32

If all goes well, the rightmost LED (power) is green and the leftmost (WLAN)
and middle (wired network) LEDs flash whenever there is traffic on the
respective networks which is at least ten times per second for the wireless
LAN because of so-called ‘beacons’.
The Access Point automatically selects the medium attached. When no cable
network is detected, the network LED will turn red.
When the supplied power is too low or unstable the power LED will turn red.
The power LED will also turn red when the firmware of the Access Point has a
fault condition.
You can reset the Access Point’s
settings to factory defaults by pushing
a paperclip in the little hole next to the
power switch while switching the
Access Point on.
When you push a paperclip in the reset
hole while the Access Point is switched
on, only the lock set by APCenter™
(Par 4.5) is deactivated.