NKT Photonics Koheras ACOUSTIK, Product Manual

Page: 63 / 96

63
CONTROL settings
The Emission button indicator turns ON RED when at least one or more modules
have emission enabled. Otherwise, it is OFF GREY.
Note: BOOSTIK LC modules receiving input from a seed module that fails to en-
able emission, will also be unable to turn on.
Warning: Class 3B laser emission is emitted from inserted ACOUSTIKmodules
when the Emission button LED is ON RED.
Warning: Class 4 laser emission is emitted from inserted ACOUSTIK modules
when they are turned on using their emission button - see Procedure 6 on
page 54 .
CONTROL settings
CONTROL settings for the system are accessible by selecting the ACOUSTIK in
the
Device Selector panel and clicking the gear icon in the upper right corner
of the Status panel. Clicking the gear icon displays a menu of setting items as
shown in
Figure 26 .
Note: The number of items in the settings menu may vary depending on the
module types inserted in the ACOUSTIK system.
IMPORTANT The settings described in this section are the ACOUSTIK system
settings - when a module is selected in the Device Selector panel, the settings
menu is for the single module only. Refer to the module documentation for
information on these settings.
Figure 26 ACOUSTIK CONTROL settings
Setting Item Function See
Wavelength
modulation Sets up wavelength modulation for inserted BASIK
modules.
Wavelength modulation on
page 64
Amplitude
modulation Sets up amplitude modulation for inserted BASIK
modules.
Wavelength modulation on
page 64
Ethernet Sets the IP configuration of the system Ethernet port. Ethernet on page 70
Click the gear icon
to access the menu