NKT Photonics A301-100-000, Product Manual

Page: 36 / 47

Control panel
36
“Bandwidth restrictions” settings to change the Bandwidth slider scale to permit
the reduced bandwidth as shown in Figure 25 .
Figure 25 Reduced Bandwidth set to 3.0 nm
Using a bandwidth
greater than 100 nm
You can increase the bandwidth output from the VARIA to beyond 100 nm.
Beyond the 100 nm limit, the quality of the output spectrum is diminished. Use
the Status panel “Bandwidth restrictions” settings to change the Bandwidth slider
scale to permit the increase in bandwidth as shown in Figure 26 .
Figure 26 Increased Bandwidth set to 247.0 nm
Note: The VARIA output center wavelength can only be adjusted within an oper -
ating range specific to the model. Center wavelengths entered outside the
range, are replaced by a wavelength at the nearest limit of the operational range.