NKK SWITCHES IS-L02A1-C, User Manual

Page: 6 / 14

LCD 64x32 Logic Boards Users Manual
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
LCD 64x32 Logic Boards Users Manual B.doc
Page 6 of 13
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone 480.991.0942 • Fax 480.998.1435
www.nkkswitches.com • Email engineering@nkkswitches.com 0410
The logic boards have two connectors:
J1
Input port: 7x2 male header .1”x.1” spacing.
This connector connects to the controller port or J2 of the previous logic board in the daisy chain.
Pin Function
1 Din Connected to Din of all SmartSwitches
2 GND Ground
3 CLK Clock for all shift registers
4 GND Ground
5 NC
6 +9V 9V Supply
7 LP Latch all shift register outputs to the all drivers
8 oe Driver Output Enable. Can be connected to gnd.
9 SCK SCK of all SmartSwitches
10 VLC VLC of all SmartSwitches
11 SDI SDI of the all SmartSwitch
12 +9V 9V Supply
13 NC
14 SWRD Switch Read bus for all SmartSwitches
J2 Output port: 7x2 male header .1”x.1” spacing.
This connector connects to J1 of the next logic board in the daisy chain.
Pin Function
1 Dout Connected to Dout of the last shift register
2 GND Connected to J1
3 CLK Connected to J1
4 GND Connected to J1
5 GND Connected to J1
6 +9V Connected to J1
7 LP Connected to J1
8 oe Connected to J1
9 SCK Connected to J1
10 VLC Connected to J1
11 SDI Connected to J1
12 +9V Connected to J1
13 GND Connected to J1
14 SWRD Connected to J1