Temp’n’Glow IN‐16 Nixie Thermometer Documentation
6
4
=
Units
The display shows "4x", whereby the value x has the range from 1‐2
(factory setting)
.
The values of x have the following meanings:
= The tubes show the temperature in the unit ° C
= The tubes show the temperature in the unit ° F
1
2
as the range from 0‐1.
5
=
CP
Prevention
x" whereby the value x h
ngs:
The display shows "5
The values of x have the following meani
= Prevention is off
0
1 = CP Prevention is on (factory setting)
If CP prevention is switched on, the Cathode Poisoning Prevention is executed every 5 minutes.
This is done as follows:
t tube and the right decimal dot of the right tube is
The minus sign or the left decimal dot of the lef
switched on.
The digits 0‐9 are scrolled through both tubes.
uration of the scroll operation: 4 seconds
fter having done that the display will show the temperatures again.
D
A
5 Display
limits
I
f the (theoretical) temperature is below ‐99 or over +99 ° C or ° F the display still shows ‐99 to +99.
6 Error
indication
If one of the sensor is not connected or produces a bad signal, then "99" is di
he left decimal point blinks left in the rhythm of 0.25 seconds (no cross‐fadi
he right decimal point of the right tube remains unchanged in its function.
splayed and the minus sign or
ng).
t
T
7 Special Notes on the IN-16 tubes
There are several variants of the IN‐16 tubes. One has a hole with Ø 4 mm in the spacer, the other has not.
Here you can see this difference:
With hole:
without hole
f you fit any under body lighting tubes, this difference is not important to you. However, if you install an
I
under body lighting, you have to refer to the following.
If you use the version with a hole in the spacer, there is no need to change anything, because the LED
exactly fits into this hole.
But if you use the version without the hole, then you have to drill a hole of Ø4, 5 mm into the middle of the
spacer. To do so, slide away the spacer from the tube and drill the hole.
Note:
From
Nocrotec
you
get
matched
tube
sets
WITH
hole
in
spacer
for
the
LEDs
)
