Instruction Manual
OCM F
Page 40
OCM F - Rev. 04 as of 18.02.2014
®
9
Parameter Setting
9.1
Basics
The transmitter in the background operates with the settings which have been
entered at the beginning of the parameter setting. The system will not ask to ac-
cept the modifications before the settings or modifications have been finished.
Enter the PIN below in order to accept modifications.
2718
type in 2718 if prompted.
Never give the PIN code to any unauthorised persons. Even do not leave the
code next to the equipment or write it down on it. The code number protects
against unauthorized access.
The unit will accept modified parameters if entered correctly performing a re-
start subsequently. The OCM F is ready for operation after approx. 20-30 sec-
onds.
It is possible to save modified parameters at the end of the parameter setting
procedure.
Entered parameters may be saved at the end of the setting procedure (>accept
changes<) or rejected by pressing >cancel<. It is also possible to jump back to
the previous level using the >back< function. This enables the user to modify
settings which might have been forgotten without the need to buffer previously
modified settings.
Fig. 9-1
Screen on end of parameter setting
Modifications concerning language, units and contrast do not require the PIN
code to be entered as these settings influence just the way of representation and
not measurement or output.
If parameter settings are not going to be modified but just verified by selecting
each parameter, there will be no PIN request at the end of the dialog.
Summary of Contents for osm-f
Page 24: ...Instruction Manual OCM F Page 24 OCM F Rev 04 as of 18 02 2014 Fig 7 3 Clamp wiring OCM F...
Page 102: ......
Page 103: ......
