Instruction manual
NivuSonic Clamp on
®
The initial start-up dialog is the language selection:
Fig. 8-2
Language Selection
Select the desired language by using the arrow keys and press >Enter< to con-
firm.
Please press key once
The transmitter begins communication evaluating the flow velocity and coordi-
nates both processor programs. At the same time, you see the current versions
of CPU and sensor software on the display. This is required if problems should
arise during programming.
Due to safety reasons please reset the system afterwards (menu PAR / sub-
menu “setup parameter“).
Now you are ready to begin setting your parameters.
The system reset is allowed to be carried out only for a new unit. Custom pa-
rameters will get lost performing a reset and the unit will reset to factory de-
faults.
NivuSonic CO - Rev. 00 as of 08.12.2010
Page 49
Summary of Contents for NivuSonic Clamp On
Page 109: ...18 Declaration of Conformity...
Page 110: ......
