Nivus NivuLog Easy V3, User Manual

Page: 89 / 141

Chapter 10 User interfaces
All other
modes
(2/2) Level trigger ON Activate online mode
RA The alternative record interval should be used.
OS If this checkbox has been selected, the setpoint output is only
released on the switchable sensor supply output VOUT if the trigger is
active. See "Example for explaining the release of the setpoint at the
output via the trigger" on page 92.
O3 If this checkbox has been selected, the setpoint output is only
released on the switchable sensor supply output VOUT if the trigger is
active.
OD If this checkbox has been selected, the setpoint output is only
released on the isolated switch contact (NO, CC) if the trigger is
active.
QX The alternative transmission cycle should be used.
Threshold Levels for initiating the trigger. The hysteresis is used to determine the
level to reset the trigger.
Greater or
equal The trigger is active as long as the measurement
value is higher than the level or equal to the level.
Less or equal The trigger is active as long as the measurement
value is lower than the level or equal to the level.
Hyst Hysteresis for revoking the trigger (e.g. hyst=5%, level = greater or
equal, trigger at 100 -> reset at 95)
Note: If one of the "OS", "O3" or "OD" checkboxes has been selected on several measurement
channels (this also applies to internal measurement channels), the setpoint output for the
corresponding output channel is released as soon as the trigger is active on one of the measurement
channels, i.e. it is an "or" conjunction.
10.2.1.1.4 Output channels
Ext. warmup time
Indicates the amount of time that an output channel is switched on in "Ext warmup time" mode before
the measurement
Title voltage
Switchable sensor supply (VOUT)
Title 3V3
Switchable 3,3V supply (VEXT)
Title digital
Isolated switch contact (NO, CC)
NivuLog Easy V3 - Rev. 03 as of 24.10.2018 89 of 141