Nivus NivuFlow 750, Instruction Manual

Page: 51 / 162

Putting into Operation
NFM 750 - rev. 03 / 27.05.2020 page 51
Fig. 31-18 Confirm adding
The link (Fig. 31-19 no. 1) is indicated on the start screen and can be used for instant access
without the need to specify the IP address.
This link can be used for each further NivuFlow Mobile transmitter after it has been selected
from the WLAN list.
Fig. 31-19 Link in the start screen
31.4 Windows Operating System

Preparing the NivuFlow Mobile:
1. Ensure power supply: a minimum of one completely charged rechargeable bat-
tery pack either plugged into the instrument or alternatively connected via the
multifunction socket (see chapter “23.1.3 Operation/Charging via an Alternative
Power Supply”).
The following step “Wake-Up” can be skipped as soon as the battery pack is in-
serted now or when voltage is fed and the connection is set up within the follow-
ing five minutes.
2. “Waking up” NivuFlow Mobile: hold the accompanying magnet (solenoid, Fig.
31-20 no. 2) to the reed contact (Fig. 31-20 no. 1; front side of NFM) until the
LED is lit.