Nivus NivuFlow 750, Instruction Manual

Page: 41 / 162

Installation and Connection
NFM 750 - rev. 03 / 27.05.2020 page 41
26 Single external Connection for Inputs/Outputs
If there is one additional sensor or actuator to be connected by using the inputs/outputs be-
sides the sensors connected for flow velocity or level measurement, this can be done directly
via the connection cables for the multifunction socket. Depending on the intended purpose
there are different cable types available. All cables feature open cable ends on one side and
a plug for the multifunction socket on the other side.

For article numbers see chapter “55 Accessories”.

For more than one external connection see chapter “27 Connecting the Con-
nector Box for Inputs/Outputs”.
27 Connecting the Connector Box for Inputs/Outputs
A Connector Box (Fig. 27-1 no. 6) must be used if you wish to additionally connect more
than one sensor or actuator using the inputs/outputs besides the flow velocity / level sensors
on the NivuFlow Mobile 750 (Fig. 27-1 no. 1).

For only one single external connection refer to chapter “26 Single external
Connection for Inputs/Outputs”.
Important Note
The Connector Box can either be fastened directly on the NivuFlow Mobile by using the
hoop guards (Fig. 27-1 no. 2) or can be put/fastened to any other place.
Fig. 27-1 NFM with Connector Box (example)

How to fasten the Connector Box on the NivuFlow Mobile:
1. Remove the rubber buffers (not depicted) from the reverse side of the NivuFlow
Mobile (Fig. 27-1 no. 1). Both fastening plates (now loose, Fig. 27-1 no. 3) with-
in the screw channels (Fig. 27-1 no. 4) and the rubber buffers are already re-
quired for the next step.
2. Fasten the hoop guards (Fig. 27-1 no. 2) on the NivuFlow Mobile by using the
rubber buffers.
3. Fasten the Connector Box (Fig. 27-1 no. 6) on the hoop guards by using the
accompanying screws.