Instruction Manual
NivuFlow 650
page 168
NF 650 - rev. 01 / 29.06.2020
50 Installation of spare parts and parts subject to wear and tear
We hereby particularly emphasise that replacement parts or accessories not supplied by
NIVUS are not certified and approved by NIVUS.
Installation and/or the use of such products hence may negatively influence predetermined
design characteristics of the measurement system or even lead to instrument failures.
The legally associated companies and subsidiaries of NIVUS group cannot be held respon-
sible for any damage resulting from the use of non-original parts and non-original accessories.
F
c
A selection of NIVUS GmbH accessories can be found in Sect. “51 Accessories”.
Further information on spare parts and accessories can be obtained from your local
representative/regional office or directly from NIVUS GmbH.
51 Accessories
ZUB0 NFWx
Field enclosure in various designs to protect the NivuFlow outdoors
ZUB0 SPSYS 08
Clamping system for clamp-on measurements, consisting of tensio-
ning belt, width 8 mm (length 10 m for 2x 5 m) and two turnbuckles
for fastening of two sensors; incl. coupling paste
ZUB0 CORA x
Mounting system (for clamp-on sensors) in different versions
ZUB0 KOP 100
3 pairs of coupling pads; transparent; 0.5 mm thick
ZUB0 SPx
Endless clamp belt and head; 12.7 mm wide
BSL0 x
Various surge protection devices for power supply, sensors and data
lines for the NivuFlow 650
ZUB0 USB 08
8 GB USB stick for readout of parameters and readings
SW0 NS PRO
Evaluation software, NivuSoft Professional with matched functions:
documentation of measurement sites, output as graphs and tables,
creation of statistics/reports etc.
Table 51-1 Accessories for transmitter NivuFlow 650
Further information on spare parts and accessories can be obtained from your
local representative/regional office or directly from NIVUS GmbH.
