Setting Parameters
page 127
NF 650 - rev. 01 / 29.06.2020
For communication via HART (using AO1) the ID information of the connected device needs to
be specified.
Fig. 35-3
HART
35.4 Modbus
It is possible to integrate the transmitter into other systems via Modbus.
The Modbus protocols are available upon request if required. Contact the NIVUS GmbH
headquarters in Eppingen.
Fig. 35-4
Modbus
The functions below are available here:
• Slave address (1 to 247)
• TCP (Port used)
• RTU
Interface (RS232 or RS485)
Baud rate (1200, 2400, 4800, 9600, 19200, 38400, 57600 or 115200 baud)
Parity (None, Odd or Even)
Stop bits (1 or 2)
The following scaling can be set, as well:
• Scaling flow
• Scaling level
• Scaling velocity
