22
Cleaning & maintenance
CAUTION
Clean the brewing unit before every clean-
ing program, but at least once a month.
Otherwise, the warranty can be void.
CAUTION
Never immerse the machine in water!
Do not use scouring agents for cleaning.
Dried milk residue is hard to remove.
Therefore, always clean immediately after
the machine cools down! Always follow the
message / instructions in the display on
rinsing and cleaning the frother.
Unlock
brewing unit
Open/close
service door
8.6. Remove & clean brewing unit
The brewing unit should be removed and cleaned under running water as needed and before
each cleaning program. Please never use detergent, but only pure
cold water!
Open the service door on the right side of the housing (gently pull the unlocking device
inside the handle upward, then carefully remove the service door from the housing)
Unlock brewing unit (press red switch upwards and turn the handle to the left up to the
stop and to lock)
Carefully remove the brewing unit with the handle
Clean brewing unit under cold, running water and
then let it dry
Carefully insert brewing unit again and lock it (hold down red switch and turn the handle
to the right up to the stop and to lock it)
Close service door again (guide pins on the bottom of the service door into the
recesses, then press the service door until it locks in place)
8.7. Clean regularly by hand
NOTE
Please follow these cleaning instructions. Maximum cleanliness is required, especially when handling
food and beverages.
When cleaning the drip pan, make sure that the two metal contacts and the space between them at
the rear of the drip pan are always clean and dry. Occasionally use some soapy water to clean the
drip pan.
The machine is equipped with rear rollers. These permit movement on a flat work surface. This
allows cleaning under the machine.
