15
➔
Then press the steam warm-up
button (fig. 1/P and 7). The ‘steam
/ hot water’ symbols (Symbol 15)
flash.
➔
As soon as the system is ready,
Symbol 16 starts flashing and
Symbol 15 lights up.
➔
For cappuccino: now turn the
‘spumatore’ control knob (fig. 9a)
to the left so that it points to
‘cappuccino’.
➔
For hot milk, turn the ‘spu -
matore’ control knob (fig. 9a) to
the right so that it points to ‘caffè
latte’.
➔
Turn the steam / hot water valve
control knob (fig. 1/Q and 7) slowly
to the right.
➔
As soon as the desired amount
of milk foam or hot milk has been
drawn, turn the steam / hot water
valve control knob (fig. 1/Q and 7)
back left to the ‘0’ position.
➔
Press the steam warm-up but-
ton again (fig. 1/P and 7).
➔
Now place the cup with the
frothed up or hot milk under the
coffee spout (fig. 1/J and 5) and
fill with coffee as described above.
Caution:
It is hard to remove dried
milk left on the jet after frothing.
Please therefore clean the equip-
ment as soon as it has cooled
down.
➔
To do this, fill a container with
cold clean water, and dip the inlet
hose into it.
➔
Place an empty container under
the ‘spumatore’ jet (fig. 1/T and 8).
➔
Now draw steam (as described
in points 3.7 and 3.8) until only
clean water / steam flows out.
➔
Now the whole ‘spumatore’
mechanism is clean and operational
again.
Cleaning:
For optimal cleaning the
‘spumatore’ must be dismantled
from time to time and its parts
rinsed under fresh, cold water. It
is easy to take apart and re-
as semble (see fig. 9).
Note:
Steam can be drawn for
about 2 minutes. Then the machine
will automatically switch the
operation off. You can prolong the
operation by turning the control
knob (fig. 1/Q and 7) back and
forth.
... 3. Making coffee
