Nitto Kohki HB-15B, Instruction Manual

Page: 8 / 10

7
Fig.12
Clamp Lever Moter
Body
(2) Remove the Nuts for Roller Bearing shown in
Fig.13 using the Spanner and Hook Spanner
included in the accessories, and then extract the
Holders A and B in the direction of the arrow.
(3) Mount the Holders A and B in the proper direction
(so that projected portions of the Holders A and B
face each other), and then firmly tighten the Nuts
for Roller Bearing using a Hook Spanner. (Fig.13)
Fig.13
Nut for Roller Bearing AN03
Adapter
Motor
Mount so that some
clearance is left
Holder A
Holder B
6 MAINTENANCE AND INSPECTION
WARNING
●
Be sure to turn the switch OFF and remove
the power plug from power supply during
maintenance and inspection.
●
Perform periodic inspection to check for
loosening of the attachment screws for each
part. Retighten loose screws as required.
7 CONDITION FOR USE
Burn-out chips suggest that either the feed speed
is too slow or the Indexable Inserts have worn-out.
Change the cutting conditions or check the conditions
of the Indexable Inserts.
8 ORDERING SERVICE PARTS
For further operational and handling information or
for replacement of parts and components, contact the
company from whom you purchased the tool or an
authorized dealer.
In ordering parts and components, give each part
number, part name and quantity required.
Use only NITTO genuine parts.
9 OPTIONAL PARTS
Part No. Description Qty
TA9A093
Indexable Insert 12.7 Ass’y
(12pcs./set)
1 set
TA9A728 Plate Ass’y for Pipe ※ 1 set
※ For Pipe Out Dia. 125mm – 800mm
Mount so that some clearance
is left