- 8 -
7-3) How to Make a Finger Joint - Continued-
④
The cutting arm is rotated to the cutting seat
side, and Insert the protrusions of the slide base
to the ditches of the pitch gauge.
⑤
Hold the finger puncher in place with one hand
and push down the handle with the other hand
to punch the belt.
※
After it is confirmed that the protrusions of
the slide base inserted the ditches of the
pitch gauge, the belt is punched.
⑥
The wing nuts are loosened, and line up the
second mark on the belt with the corner of the
belt guide, and the wing nuts are tightened, and
the belt are fixed.
⑦
The operation described to
④
-
⑥
is done again,
and punch out the belt to obtain the required
endless length.
※
When punching a long belt, you can insert
the rear–edge of the belt from the other side
of the finger puncher to avoid pulling the
entire belt through the finger puncher.
クランプバー
Pitch Gauge for back side
Pitch Gage for back side
Fit the fast mark with the
corner of the belt guide.
Summary of Contents for FP70-10-100
Page 15: ...14 Memo...
