Nitta FP-200T, Operator'S Manual, Page: 9 / 18

- 8 -
7-3) How to Make a Finger Joint
①
Loosen bolt on clamping bar and insert a
belt end in one side of finger puncher.
②
Place the belt to coincide marks on the
belt and the table.
③
Fasten the bolts on both clamps with a
wrench to secure the belt position.
※
Do not tighten bolts tight.
（
2 N · m or less
）
④
Continuous punching
After punching one end of a belt, pull out the
Belt through clamping bar until next
punching position.
⑤
Both ends cut belt
Each ends must be insert from opposite
side clamping bar and place the same side
edge of groove of the clamping bar.
⑥
Align the support table so that guide pins
on the cutter line up with a set of
alignment holes on either end of the
clamps.
⑦
Push downward on the handle carefully to
check the alignment of the pins.
⑧
Return the handle and move the support
table over so the next set will accept the
guide pins.
⑨
Repeat step
⑥
-
⑧
.
NO
200
㎜
Clamp bars Cutting Sheet
Belt
Mark 200 ㎜ joint length on the table.
Set both belt ends to same side of the
clamp