EN © 2022 NITEO TOOLS. All rights reserved.
Battery compressor
24
NITEO TOOLS
perfect technical condition, it cannot be put into service. If the unit is damaged, it
must be repaired before it can be used again.
The DC 5.5x2.1 mm connector on the underside of the device is designed
for direct power supply e.g. from a car lighter socket. The suitable cable is
not included.
In the case of pumping large items, the pumping time may be several
minutes or more, depending on the size of the pumped item. Therefore, in
such situations, we recommend that you use the compressor only to pump up the
partially inflated product.
In the case of pumping, e.g. car wheels, we recommend that the
compressor be directly powered from the car lighter socket - the
appropriate cable is not included in the set. This will ensure the appropriate
operating parameters of the device.
To turn the device on press and hold the ON/OFF button (5) for approximately
3 seconds. The LCD display (2) will turn on and light up blue. When the
compressor is switched on, a short press on the ON/OFF button turns the
pumping on and off.
Pressing and holding the ON/OFF button (5) again for approx. three seconds
will switch off the device.
INFLATING
Connect a suitable tip to the compressor and then to the object which you
want to inflate. Switch on the compressor, adjust the unit of pressure using
the unit selector button (4) and then set the target pressure of the object to be
inflated using the pressure control buttons. When the ON/OFF button is
pressed briefly an object connected to the compressor will be pumped, which
will stop automatically when the target pressure is reached in the object to be
pumped. Pumping can also be stopped at any time by briefly pressing the
ON/OFF button. Remember not to exceed the pressure specified by the
manufacturer of the item being inflated. Failure to comply with this rule may
result in damage to the item and may pose a safety risk to the compressor
