24
Calling the Patrol (Tour)
To initiate a patrol or tour enter <
CALL> <nnn> <Enter>
or
<SHOT> <nnn>
<
Enter
> on the keypad. (where
nnn
= 231 ~ 238) e.g 231 = Patrol 1, 232 = Patrol
2 etc.
Alternatively dependent on PTZ firmware installed in PTZ630 you can enter
<
CALL> <nn> <Enter>
or
<SHOT> <nn>
<
Enter
> on the keypad. (where
nn
=
65 ~ 68) e.g 65 = Patrol 1, 66 = Patrol 2 etc.
Special Note:
If you notice that some expected presets are not being incorporated in
the patrol/tour, check that the PRESET table has been setup correctly and shows all
presets for the required sequence.
TIP - To stop the PATROL just move the joystick slightly.
AUTO SCAN- How to set it up
Auto-scan
scans between two points. These are not presets as per the patrol (tour)
facility but auto scan selection points. You may program one auto scan.
Select the required camera by pressing the <
CAM> or <Addr>
button and then
entering <camera number> followed by <
Enter
> on the keypad.
To setup the Auto Scan you need to move to the start position and enter <
CALL> 221
<Enter>
or
<SHOT> 221
<
Enter
> on the keypad.
Alternatively dependent on PTZ firmware installed in PTZ630 you can enter
<
CALL> 92 <Enter>
or
<SHOT> 92
<
Enter
> on the keypad.
You will see the message "
A point has been set
" displayed on the screen.
Now move to the end position of the Auto Scan and enter <
CALL> 222 <Enter>
or
<SHOT> 222
<
Enter
> on the keypad.
Alternatively dependent on PTZ firmware installed in PTZ630 you can enter
<
CALL> 93 <Enter>
or
<SHOT> 93
<
Enter
> on the keypad.
You will see the message "
B point has been set
" displayed on the screen.
You can however setup the Auto Scan through the menu system to be triggered by an
alarm.
Move down to
System Setting
and press the OPEN button or IRIS+ button on the
keypad and move to the
Movement Control
menu use the up and down direction
keys on the keyboard. Now press the OPEN button or IRIS+ button to enter the
Movement Control menu.
Move down to
AB Scan Setting
using the up and down direction keys on the
keyboard. Press the OPEN button or IRIS+ button to display
"Set A Point First"
.
