8
Wireless Flash Shooting
Pairing Setting
Step 1: Set all NAS flashes and NAS receivers to pairing mode.
Step 2: Binding on Flash Commander
To perform wireless shooting, set the Nissin Air 10s commander and
NAS slave unit with the following procedure. After pairing is completed, both of them
will memorize the data and there will be no need to pair again after the units are
switched on and off.
NAS
1. Make sure the Nissin MG10 is off.
2. Rotate the "Ch" channel dial to "Auto" auto channel mode.
Nissin flash MG10
3. Hold the "Open" button and the power button for 3 seconds.
3. “Beep” sound persists until the Pairing signal is received.
When the "beep" sound stops, the pairing is complete.
1. Make sure the Nissin Air 10s is off.
2. Hold both Panel Lock button and Power on/off buton for 3 seconds
until the pilot light is blinking in orange colour.
Nissin Air 10s
Summary of Contents for MG10
Page 1: ...INSTRUCTION MANUAL ...
