Battery Installation:
1.
Remove the black screw from the rear cover to open
the battery compartment.
2.
Be sure to check polarity of batteries before installing.
3.
Install 2 x AAA batteries. Batteries may be alkaline
(1.5v), NiCad or NiMH (1.2v) rechargeable batteries.
Power can also be supplied using the included USB
cable. The USB port is intended for continuous power,
but will not charge the batteries.
4.
Remove the batteries if the unit will not be used for an
extended period.
Measurement:
1.
Connect the transceiver to the “TX” connector on the RS
-
50M meter using a 1 meter length of 50-ohm cable (sold
separately)
2.
Connect the antenna or load to the "ANT" connector.
3.
Turn on the RS-50M power and optionally the LCD back-
light switch.
Summary of Contents for RS-50M
Page 1: ......
