61
ENG
MEMORY FUNCTION
The measured values are automatically saved for later review in either one of two memory banks. These
two memory banks can be used to save readings of two persons separately or to save morning readings
and evening readings separately.
Each bank can save up to 60 readings. When the number of stored readings reaches 60, the oldest
reading will be deleted to record new reading.
Saved readings are recalled with measurement date and time when clock function is activated. *The
clock needs to be activated before measurement for date and time to be saved with the measured
valued.
[Err] results are not saved.
1 Turn
off the monitor once with “START/STOP” when the results are displayed after a measurement.
Press to review readings saved in memory 1 and to review those in memory 2.
The average of the saved readings are displayed (fi g. 20).
Average will not be displayed unless there are two or more readings saved.
2 Press the same memory key again. The latest reading saved in the
selected bank is displayed.
3 The display at the top shows memory number, measurement date and
time alternately.
4 The latest reading is displayed as memory “No. 1”. The bigger memory
number indicates the older number.
Even if you do not turn off the monitor, it displays the result for
approximately 30 seconds and will turn off automatically.
Pressing at display of reading in the bank M1 will switch the display to
reading in bank M2 and pressing side again will return to the display of
result in the bank M1.
5 Press “START/STOP” .
Deleting saved readings
The readings can be deleted from the memory. The memory can be initialized only when two or more
results are saved in the bank.
1 Press to delete reading in MEMORY 1 or to delete reading in MEMORY 2. Display the average
reading of to delete entire readings in the memory.
2 The display will start fl ashing. Keep your fi nger on the key until the reading is replaced with «---».
Fig.20
