30
1: Wear mark
2: Wear limit indication
SERVICE AND MAINTENANCE
4. Measure the gap between pole and electrode with a thickness gauge and adjust to 0.6 - 0.7 mm.
5. When re-installing the spark plug, screw it in by hand and then tighten with the wrench (1/2 turn for
a new plug, 1/8-1/4 turn for a used one).
5. Put on the spark plug cap.
Tyres
The inflated tyre pressure must be checked daily and regulated according to the
following table. Cracks, damage, and wear on the tyres cause unsteady steering or
even tyre blow-out. Note that tyre pressure is measured with cold tyres.
Note: 1 bar = 1 kg
f
/cm
2
= 100 kPa
Driving with worn tyres is very dangerous. The tyres must be replaced before the tread is worn to the
wear mark
(1)
.
Tyre specifications
Tyre pressure in cold state
Rider only
Rider and
passenger
Front wheel 3.50-10
2.50 bar
2.75 bar
Rear wheel
3.50-10
2.50 bar
2.75 bar
!
WARNING:
- The spark plug must be screwed in fully. Otherwise, leakage from spark plug base and temperature increase
may occur resulting in engine damage.
- Do not use a spark plug with incorrect heat value; otherwise the engine could be severely damaged.
