FAILURE
CAUSES
SOLUTIONS
The scooter has no electricity, and
the READY lamp does not shine.
Battery is poorly connected.
Power
switch is not turned on.
Connect the battery properly at its main
plug. Turn on the
power switch
.
When turning the speed regulating
steering handle-bar, the motor
does not turn after being powered.
Low battery volume.
Side stand is not retracted.
Brake handle does not reach the
right position. Steering handlebar
failure.
The controller plug is loose.
Controller failure.
Charge the battery.
Put away the side stand. Close the parking
key.
Place the brake handle at the right
position. Change handlebar.
Re-plug controller. Change controller.
Speed is slow or mileage is short.
Low battery.
Under-inflated
tire.
Heavily
overloaded.
Brake
pads
interference.
Battery aging or normal scrap.
Charge the battery.
Inflate the tire, and check the tire pressure
before riding.
the brake pads and check the brake system
before riding. Change battery.
Check whether the main plug is in a right
place Use the special charger.
Battery can not be charged.
Poor contact of the main plug of
the charger. Do not use the wrong
charger.
Battery aging or normal scrap.
Battery low-voltage protection.
Connect the main plug again.
Contact with local service office of battery.
Regular Inspection and Maintenance
The new scooter must be subject to the first inspection and maintenance in the Service Center when it reaches 1,000 km
or two months (whichever comes first). The scooter is recommended to be subject to regular inspection and maintenance
in the Service Center at every 3,000 km or six months (whichever comes first).
Foster a good habit, and keep the appropriate load Change.
TIPS:
Please disconnect the
power switch
before cleaning.
Do not use strong water jet to directly wash it, so as to avoid the fault of mechanical parts caused by being damped.
Regular maintenance can improve the service life and driving safety of the electric scooters. Please refer to
the fol-lowing suggestions and take care of your scoote
r.
Storage, Maintenance and Transportation
Please charge the battery to half-saturation state when storing or transporting it (after the battery is discharged, charge it for 3 hours),
Place it in a dry and ventilated place.
Battery and charger should be kept in a clean, dry, and ventilated place. Keep them away from corrosive materials, power source
and heat source; Storage conditions: ambient temperature -20-35 °C, humidity <65% RH.
When storing the charger, please disconnect it from the battery.
Regular maintenance can enhance the service life and driving safety of the electric scooter. Please refer to the following suggestions
and take care of your scooter.
Battery and charger should be kept in a clean, dry, and ventilated place. Keep them away from corrosive
materials, power source and heat source; Storage conditions: ambient temperature -20-
35 °C, humidity <65%
RH;
When storing the charger, please disconnect it from the battery.
Regular maintenance can enhance the service life and driving safety of the electric scooter. Please refer to the
following suggestions and take care of your scooter.
Summary of Contents for Cit-e
Page 1: ...C i t e...
Page 10: ......
