Keep the controller under working, press Macro button for 3s and LED flash
slowly and step into Marco programming mode, release
“Macro” button, press
the buttons need to be set in turn. And press the Macro button be set saving
record.
Eg: Set A and B and X to macro button, press
“M” button 3s and then LED
indicator flash slowly, release
“M” button to press A button and then you can
wait after 1s to press B button, and 3s later to press X button, press
“M” button
finally to save and exit the mode. Then the Macro button is Button A ---1s
button B --- 3s Button X.
When you setting some buttons, the controller could record the buttons setting
interval time.
C. Clear Macro Function:
When controller under working mode, press the
“M” button 5s, the LED light
from blinking turns to keep lighting, then all macro buttons function cleared.
Turbo function:
A. Set Turbo function:
1. Press the turbo and then press the turbo the button you want to set turbo
mode. Hold both two buttons to enter turbo model for the button.
2. Let go of the buttons and you can use the button in turbo mode now.
3. You can set turbo mode for
“A,B,X,Y,L,ZL,R,ZR” buttons and the “UP,
DOWN,LEFT,RIGHT
” of Dpad
B. Auto Turbo Function: Repeat Step A-1 to turn on the Auto turbo function
C. Clear Turbo Function: Repeat Step A-1 again to exit turbo function.
3. How to remove Joycon from Nintendo Switch devices
1. Switch Console
Find the
“remove” button the back of Joycon and slid Joycon from bottom to
top while holding down the state. Release the
“Remove” button when Joycon
completely disconnects from the device.
2. Joycon Strap
Pull down to remove the white lock and hold the Joycon wristband and slide
Joycon down until the wristband completely disengages (no need to press the
remove button on the back of Joycon).
