10
11
ninjakitchen.co.uk
TROUBLESHOOTING GUIDE
CARE & MAINTENANCE
WARNING: To reduce the risk of shock and unintended operation,
turn power off and unplug unit before troubleshooting.
CLEANING
1
Separate all parts.
2
Wash all containers in warm, soapy
water with a soft cloth.
3 Hand-Washing
Wash cups, lids and blade assembly
in warm, soapy water. Use a
dishwashing utensil with a handle to
avoid direct contact with the blades.
Exercise care when handling the
blade assembly as the blades are
sharp. Thoroughly rinse and air-dry
all parts.
Dishwasher
Cups, lids, and blade assembly are
dishwasher safe. Place the cups, lids,
and blade assembly on the top rack
of the dishwasher
ONLY
. Ensure the
blade assembly and lid are removed
from the cup before placing in the
dishwasher.
Motor Base
Turn off the unit and unplug
the motor base before cleaning.
Wipe motor base with a clean,
damp cloth.
NEVER
directly spray the base
with water or other liquids.
DO NOT
use abrasive cloths/pads/
brushes to clean the base, as this
can dull or scratch the surface.
RESETTING THE MOTOR
THERMOSTAT
This unit features a unique safety
system that prevents damage to
the motor and drive system should
you inadvertently overload it. If the
unit is overloaded, the motor will be
temporarily disabled. Should this occur,
follow the reset procedure below.
1
Unplug the unit from the socket.
2
Allow the unit to cool for
approximately 30 minutes.
3
Remove the container’s lid and blade
assembly. Empty the container and
ensure no ingredients are jamming
the blade assemblies.
IMPORTANT:
Ensure that
maximum capacities are not
exceeded. This is the most typical
cause of appliance overload.
Motor doesn't start or blade assembly doesn't rotate
• Make sure the cup is securely placed onto the motor base.
• Check that the plug is securely inserted into the socket.
• Check fuse or breaker in your home. Replace the fuse/reset breaker.
• Check that the inside of the motor base is clean and there is no food blocking the
connection between the motor base and the cup.
• There is too much food in the container. Unplug the motor base. Remove some food
and try again.
• The unit has overheated. Unplug and wait approximately 15 minutes before using again.
Food collects on the sides of the cup
• Too much food is being processed at one time. Turn the motor base off. When the
blades stop rotating, remove the cup from the motor base. Remove some of the food
being processed.
Snow from ice cannot be acheived
• Do not use ice that has been sitting out or has started to melt.
• Be sure to use short pulses in the beginning to break up large pieces.
