13
ninjakitchen.co.uk
12
ninjakitchen.co.uk
1
Plug in motor base and place on a clean,
dry, level surface such as a worktop or
table.
2
Lower the Total Crushing
®
Jug onto
the motor base. The handle should be
aligned slightly to the right and the Jug
should be oriented so the
LOCK
symbols
are visible on the motor base. Rotate the
Jug clockwise until it clicks into place.
USING THE TOTAL CRUSHING® JUG
3
Exercising care, grasp the Total Crush-
ing® Blade by the top of the shaft and
place it onto the drive gear inside the
Jug. Note that the blade assembly will fit
loosely onto the drive gear.
4
Add ingredients to the Jug.
DO NOT
add ingredients past the
MAX LIQUID
line on the Jug.
5
Place the lid on the Jug, aligning the
triangle symbol on the lid with the
triangle symbol on the handle. Press
down on the handle until it clicks into
place. The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate. Once the lid is locked in place,
press the Power button to turn unit
on. The available program buttons will
illuminate and the unit will be ready
for use.
IMPORTANT:
Review all warnings on
pages 4–7 before proceeding.
NOTE:
Auto-IQ® programs have pauses
and changes in speed throughout
the cycle.
NOTE:
DO NOT
add ingredients before
installing the Total Crushing® Blade.
NOTE:
If the Total Crushing® Blade is not
fully seated, you will not be able to install
and lock the lid.
NOTE:
The handle on the jug lid will
not fold down unless it is attached to
the jug. The triangle symbols MUST be
aligned for the lid to lock and the unit to
operate.
6a
If using an Auto-IQ® program, select the
program that best suits your recipe. The
preset feature will automatically stop at
the end of the program. To stop the unit
at any time, press the currently active but-
ton again.
6b
If using a manual program, select your
desired speed. Once the ingredients
have reached your desired consistency,
press the active button again, and wait
for the unit to come to a complete stop
after 60 seconds.
7
To remove the Jug from the motor
base, turn the Jug anti-clockwise
and then lift up.
8a
To pour out thinner mixtures, ensure
the lid is locked in place, then open the
pour spout cap.
IMPORTANT:
As a safety feature, if the
Jug and lid are not properly installed, the
timer will display “... ...” and the motor
will be disabled. If this happens, repeat
step 5
on the following page. When the
Jug and lid are properly installed, the
program button LEDs will illuminate,
indicating the appliance is ready to use.
IMPORTANT:
If the control panel is
flashing, this means the lid is not locked
in place correctly. Review the steps
2-5 to ensure you are installing the
disc adapter, ingredients, disc and lid
correctly.
8b
For thicker mixtures that cannot be
emptied through the pour spout,
remove the lid and Total Crushing®
Blade before pouring. To remove the lid,
press the
RELEASE
button and lift the
handle. To remove the blade assembly,
carefully grasp it by the
top of the shaft and pull straight up.
The Jug can then be emptied.
9
Turn the unit off by pressing the Power
button. Unplug the unit when finished.
Refer to the Care & Maintenance section
for cleaning and storage instructions.
