AU
02 8801 7666 |
NZ
0800 112 660
10
CARE & MAINTENANCE
CLEANING
1
Separate all parts.
2
Wash all containers in warm, soapy
water with a soft cloth.
• Hand-Washing
Wash cups, lids, and blade assembly in
warm, soapy water. Use a dishwashing
utensil with a handle to avoid direct
contact with the blades. Exercise care
when handling the blade assembly as the
blades are sharp. Thoroughly rinse and
air-dry all parts.
• Dishwasher
Cups, lids, and blade assembly are
dishwasher safe. Place the cups, lids
and blade assembly on the top rack of
the dishwasher
ONLY
. Ensure the blade
assembly and lid are removed from the
cup before placing in the dishwasher.
• Motor Base
Turn off the unit and unplug the motor
base before cleaning. Wipe motor
base with a clean, damp cloth.
NEVER
directly spray the base with
water or other liquids.
DO NOT
use abrasive cloths, pads or
brushes to clean the base, as this can
dull or scratch the surface.
STORING
Wrap the power cord around the cord wrap
on the underside of the motor base. Store
the unit upright and with the blade assembly
attached to the single-serve cup.
DO NOT
store blended or unblended
ingredients in the cup with the blade
assembly attached. Use only the spout
lid when storing blended and unblended
ingredients in the containers.
DO NOT
stack items on top of the cups.
Store any remaining attachments alongside
the unit or in a cupboard where they will not
be damaged or create a hazard.
RESETTING THE MOTOR THERMOSTAT
This unit features a safety system that
prevents damage to the motor and drive
system should you inadvertently overload
it. If the unit is overloaded, the motor will
be temporarily disabled. Should this occur,
follow the reset procedure below.
1
Unplug the unit from the socket.
2
Allow the unit to cool for approximately
15 minutes.
3
Remove the container’s lid and blade
assembly. Empty the container and ensure
no ingredients are jamming the blade
assemblies.
IMPORTANT:
Ensure that maximum
capacities are not exceeded. This is the
most typical cause of appliance overload.