8
®
w w w. shar k ninjamanuals .com
ASSEMBLY
OF THE 2.1 L
PITCHER
(Max Liquid Capacity: 2 L)
NOTE:
Ninja
®
Auto-iQ
®
Technology can sense
which container is on the
motor base. The function
lights will illuminate
depending on which
container is placed on
the motor base.
ASSEMBLY:
WARNING: NEVER LEAVE THE APPLIANCE
UNATTENDED WHILE IN USE.
CAUTION: USE CAUTION WHEN
HANDLING THE BLADE ASSEMBLY AS IT
IS VERY SHARP.
IMPORTANT: MAKE SURE THE MOTOR
BASE IS PLUGGED IN FOR USE.
1
Holding the Blade Assembly by the top of the
shaft, place it onto the drive gear (
A
) inside the
pitcher. Ensure that the attachment is seated
properly and is standing upright.
NOTE: THE BLADE ASSEMBLY WILL FIT
LOOSELY ON THE DRIVE GEAR.
2
Place the motor base on a clean, dry, level
surface such as a counter or tabletop. Press
down on the motor base to make sure the
suction cups adhere to the counter or tabletop.
3
Align and lower the pitcher (
B
) onto the motor
base. Handle should be aligned slightly to the
right of the
LOCK
symbol on the motor base.
4
Rotate the pitcher clockwise (
C
) until it locks in place
(you will hear a click when the lock is engaged).
5
The pitcher can be placed on the motor base
two ways; the handle can align with the front
right corner (
D
) or the front left corner (
E
).
6
Add the ingredients to the pitcher, making
sure they do not exceed the highest measured
marking line on the side of the pitcher.
NOTE
: When blending any kind of liquids, such as
mixtures of any drinks or smoothies, do not exceed
the
MAX LIQUID
mark (2 L) on the pitcher.
NOTE
: If you need to add additional ingredients
once the appliance is processing, turn the unit
OFF
,
open the pour spout cap, and pour the
ingredients in through the opening.
7
Holding the lid by the handle in the upright
position (
F
), place it on top of the pitcher
aligning the triangle ( ) located on the lid with
the triangle ( ) located on the pitcher handle.
Press the handle down until you hear a click.
8
The triangles on the lid and the pitcher handle
(
G
)
MUST
be aligned for the blender to turn on.
9
Plug the power cord into the electrical outlet.
The function lights will illuminate.
ASSEMBLY
2.1 L PITCHER
(Max Liquid Capacity: 2 L)
If your unit comes with this accessory, read the following instructions. For a list of what is included with this model, refer to inside flap of the box.
IMPORTANT: DO NOT OVERFILL. TO AVOID
SPILLING, DO NOT ADD INGREDIENTS PAST
THE “MAX LIQUID” LINE.
CAUTION: THE
BLADE ASSEMBLY
IS NOT LOCKED IN PLACE. IF USING
THE POUR SPOUT, ENSURE THE
LID IS FULLY LOCKED ONTO THE
BLENDER PITCHER.
CAUTION: THE
BLADE
ASSEMBLY
IS NOT LOCKED IN
PLACE. IF POURING WITH THE
LID REMOVED, ALWAYS REMOVE
THE
BLADE ASSEMBLY
FIRST.
A
B
C
D
E
F
G
