Clean the foreign matters on the spin tub shaft
1.
Cut off the power
2.
Open the panel frame,screw off the screws off middle frame, and take out th middle frame
3.
If can’t take out the foreign matters under the above condition, please open the machine rear cover
4.
Screw off the spin tub screws, take out the spin tub
5.
Clean the foreign matters on the shaft
6.
Re-install the spin tub in opposite course
Replace the rubber cap
1.
Cut off the power
2.
Open the panel frame, loose the screws of middle frame, and take out the middle frame
3.
Open the machine rear cover and take down the belt
4.
Screw off the spin tub screws, take out the spin tub
5.
Place the protection cushion on the ground
6.
Turn over the machine, make the machine base upside and keep placidly
7.
Take down the base screws, let it totally depart from the machine case
8.
Get out the rubber with tools(not damage the tub)
9.
Fix the base, turn over the washing machine and put it well
10.
Press the rubber cap into the tub by hand or tools
11.
Install the tub, belt, rear belt
12.
Install the middle frame and fix the control panel
Adjusting drain valve rod open height
1.
Cut off the power
2.
Open the machine rear cover
3.
Take out the adjusting rod, open two screws on driver
4.
Open the drain valve cover, if there id any difficulty, you can use unsharp tools to prize up the cover
5.
Take out the foreign matters by hand, if there is any difficulty, please use tools to take them out
6.
Re-install it in opposite course
Replace the drain valve
1.
Cut off the power
2.
Open the machine rear cover
3.
Take out the adjusting rod
4.
Separately heat three jointing places of drain valve by heating equipment, when heat enough, pull down the drain valve
to divorce it from the twin tub
5.
Glue the jointing place between the drain valve and tub evenly, energize upwards, install the valve
6.
Install the other parts in opposite course.
Replace the pump
1.
Cut off the power
2.
Open the rear cover
3.
Remove two wires of drain pump
4.
Separately heat two places of drain pump by heat equipment, when heat enough, pull out the pipe of drain pump by
hand.
5.
Loosen two screws of drain pump
6.
Take out the drain pump
7.
Re-install the drain pump in opposite course