Figure 10
11
Tourist 1
NE-MASF33
5) How to use transmitter to memorize waypoints and perform flying
(1) The transmitter is in GPS mode and GPS signal is normal.
(2) Move the transmitter's toggle switch 'B' to waypoint memory mode position.
(3) Move the wheel 'F' clockwise once when flying, the aircraft memorize one waypoint. Move the wheel 'F' counter-clockwise to
clear all memory waypoints. About 30 waypoints can be memorized one time.
(4) Move Left toggle switch B to the middle position after memorizing all waypoints needed.
(5) Move the transmitter to memory waypoint flight mode, the aircraft will fly to the first, seconod until the last memory waypoint.
Move the right toggle switch C to the middle position to exit current mode when flying.
6) Use Remote Controller to Shoot Video
Press 'Video' button (A) to start recording. Press 'Video' button (A) once again to stop recording.
7) Use Remote Controller to take Photo
Press 'Photo' button (D) to take photo, one pressing leads to one shoot.
8) Switch Mode 1 and Mode 2
How to switch between Mode 1 and Mode 2 .
Move the left stick to its highest position and keep pressing after powering on remote controller, then connect lipo battery to aircraft.
Now remote controller is in Mode 2 after the aircraft's self-inspection..
Move the right stick to its highest position and keep pressing after power on remote controller, then connect lipo battery to aircraft.
Now remote controller is in Mode 1.
Aircraft will remember the latest mode type and there is no need to switch between Mode 1 and Mode 2 each time.
9) Remote Controller Calibration
After long time using, it is necessary to do remote controller calibration to correct deviation. Calibration procedures are here:
Make sure remote controller is off. Keep pressing 'Video' button, gently press Power button one time and long press it for 2
seconds, then release all the buttons. Remote controller status indicator light blinks red and it sounds 'di--, di--'. Now Remote
controller enters into calibration mode.
Move the left and right stick to its maximum position in four directions: up, down, left and right, then move Camera pitch control
scroll wheel and way point memory wheel to its maximum position on the left and right.
Press 'Photo' button to quit calibration, turn off the transmitter to complete the calibration..
8 Preparation Before Using
1) Download, install APP
NOTE: APP in the following description may not be the latest version,
'
Nine Eagle Technology
'
will continue
updating. Please log on Nine Eagle Technology official website for the latest
information, or log on 'google play' to check below page.
https://play.google.com/store/apps/details?id=com.cam.mola&hl=en
Or open your mobile browser to scan QR code, you can directly enter into the download page to
download MOLA APP.
After the download is complete, follow the prompts to install the APP.
2) Get user manual and tutorial videos
Enter 'Technical Support' page of 'User Center' in the APP, or enter 'Nine Eagle Technology' official
website (www.nineeagle.com) to find this product introduction page. You can obtain relevant
product manuals and tutorial videos.
3) Checklist before flying
(1) Refer to 'Flying Environment Requirement', and choose the proper flying site.
(2) Check the battery level of the remote controller. Please change it when the battery level is lower than 50%.
(3) Check the battery level of the Aircraft. Please change it when the battery level is lower than 50%.
