NIMO FT 120 VP, Service Manual

Page: 32 / 44

6.4.4 Programming
Optimization of the automatic drying programmes for
the drying cabinet and activation/deactivation of the
child lock are performed in the programming mode.
1
Make sure that the main power switch
ON/OFF
on
the cabinet is in the OFF position. The display will
be black.
2
Press and hold the UP and DOWN ARROW buttons
and then move the main power switch
ON/OFF
to
the ‘ON’ position.
The display will be lit and show the parameter
’P 105
’
and the factory default value for P 105.
The line with the current parameter will flash in the
display.
3
Move to the preferred parameter by pressing the
UP
or
DOWN ARROW
repeatedly. If you go too far,
you can continue until the display shows the correct
parameter.
4
When the display shows the correct parameter,
e.g.
‘
P2132’
,
press START/STOP to confirm the
parameter selection. The line will now flash with
the set value for the parameter.
5
Increase or decrease the parameter value with the
UP
or
DOWN ARROW
button.
6
Press START/STOP to save the set value.
7
Press the
UP ARROW
and
START/STOP
to return
to the operational value.
6.4.5 Reset to factory default
1
Enter parameter display mode in accordance with
section 6.4.4.
2
Press and hold the
UP
or
DOWN ARROW
and then
press
S
TART/STOP.
The factory defaults will be saved and the display
will show the last programme used.
6.5 Child lock
6.5.1 Introduction
The child lock mode is a safety feature to prevent the
drying process from being started or stopped acciden-
tally. This functionality means that all the buttons must
be pressed for at least 3 seconds for the required activity.
This mode can be suitable for nurseries, etc.
N.B. If the door is opened during operation and closed
within 5 min., the drying process will continue. If the door
is open for more than 5 min. the drying process will end.
6.5.2 Activation
1
Enter the programming mode. See section 6.4.4.
2
Move to the parameter
‘P115’
with the UP or
DOWN ARROW.
3
Press START/STOP to save.
4
Change the parameter to the
value 1.
5
Press START/STOP to save.
6
Exit the programming mode with the
DOWN AR-
ROW and START/STOP. The child lock mode has
now been activated and is indicated in the display
with a lit ‘clock’ symbol.
6.5.3 Deactivation
1
Enter the programming mode.
2
Move to the parameter
‘P115
’
with the UP or
DOWN ARROW.
3
Press
START/STOP
to save.
4
Change the parameter to the value 0.
5
Press
START/STOP
to save.
6
Exit the programming mode with the DOWN AR-
ROW
and
START/STOP.
The clock symbol turns off.
32
ENGLISH