25
See the picture below.
5.
You measured the pitch of the holes for screws. Now you mark them as the intersection points on the horizontal line on
the wall that you already drew. Every intersection point is ½ of the measured pitch distant from the marked centre (½ X). Check one
more time if the total distance between intersection points on the wall (Y) corresponds with pitch of the holes on the mirror (X).
6.
Drill the holes to the marked intersection points. Use the correct drill and attachment components according to the type
of wall material!
If the base is suitable (it is the standard brick wall with standard plaster thickness) you can use wall plugs and screws included in the
package. Put the wall plugs in the drilled holes and use the screws whereas their head and shank stick out (max 5 mm of the visible
shank).
7.
Connect the connecting cable with the mains cable or junction box. It is recommended to work in a pair! For connecting
the cables, you can use the terminal box of article number ZP01 (in the picture) or any other terminal box with the suitable IP for
bathroom furnishing. Before you start connecting the cables, make sure there is no electric power in the supply cable! Connect the
cable of the mirror to the electric power supply to conductors L, N and PE. Terminal box is not included in the package. Use only
recommended supply voltage 230 V AC, 50 Hz, L+N+PE with front fuse max. 16 A.
aluminium
frame
line
aluminium
frame
line
aluminium
frame
line
terminal box
ZP 01
7. Instructions for assembly
ZP 8000 - ZP 59999
ZP 8000V - ZP 59999V
EN
navod-bez-7.2.indd 25
navod-bez-7.2.indd 25
26.08.2021 14:14
26.08.2021 14:14
